FCC 101.109 Revised as of October 1, 2005
Goto Year:2004 |
2006
Sec. 101.109 Bandwidth.
(a) Each authorization issued pursuant to these rules will show, as the
emission designator, a symbol representing the class of emission which must
be prefixed by a number specifying the necessary bandwidth. This figure does
not necessarily indicate the bandwidth actually occupied by the emission at
any instant. In those cases where part 2 of this chapter does not provide a
formula for the computation of the necessary bandwidth, the occupied
bandwidth may be used in the emission designator.
(b) Stations in this service will be authorized any type of emission, method
of modulation, and transmission characteristic, consistent with efficient
use of the spectrum and good engineering practice, except that Type B,
damped-wave emission will not be authorized.
(c) The maximum bandwidth which will be authorized per frequency assigned is
set out in the table that follows. Regardless of the maximum authorized
bandwidth specified for each frequency band, the Commission reserves the
right to issue a license for less than the maximum bandwidth if it appears
that a lesser bandwidth would be sufficient to support an applicant's
intended communications.
------------------------------------------------------------------------
Frequency band (MHz) Maximum authorized bandwidth
------------------------------------------------------------------------
928 to 929................................ 25 kHz 1 5 6
932 to 932.5, 941 to 941.5................ 12.5 kHz 1 5 6
932.5 to 935, 941.5 to 944................ 200 kHz \1\
952 to 960................................ 200 KHz 1 5 6
1,850 to 1,990............................ 10 MHz \1\
2,110 to 2,130............................ 3.5 MHz
2,130 to 2,150............................ 800 or 1600 KHz \1\
2,150 to 2,160............................ 10 MHz
2,160 to 2,180............................ 3.5 MHz
2,180 to 2,200............................ 800 or 1600 KHz \1\
2,450 to 2,483.5.......................... 625 KHz \2\
2,483.5 to 2,500.......................... 800 KHz
3,700 to 4,200............................ 20 MHz
5,925 to 6,425............................ 30 MHz \1\
6,425 to 6,525............................ 25 MHz
6,525 to 6,875............................ 10 MHz \1\
10,550 to 10,680.......................... 5 MHz \1\
10,700 to 11,700.......................... 40 MHz \1\
12,200 to 12,700\8\....................... 500 megahertz
13,200 to 13,250.......................... 25 MHz
17,700 to 18,140.......................... 220 MHz \1\
18,140 to 18,142.......................... 2 MHz
18,142 to 18,580.......................... 6 MHz
18,580 to 18,820.......................... 20 MHz \1\
18,820 to 18,920.......................... 10 MHz
18,920 to 19,160.......................... 20 MHz \1\
19,160 to 19,260.......................... 10 MHz
19,260 to 19,700.......................... 220 MHz \1\
21,200 to 23,600.......................... 50 MHz \1\ \4\
24,250 to 25,250.......................... 40 MHz \7\
27,500 to 28,350.......................... 850 MHz
29,100 to 29,250.......................... 150 MHz
31,000 to 31,075.......................... 75 MHz
31,075 to 31,225.......................... 150 MHz
31,225 to 31,300.......................... 75 MHz
38,600 to 40,000.......................... 50 MHz \7\
71,000 to 76,000.......................... 5000 MHz
81,000 to 86,000.......................... 5000 MHz
92,000 to 95,000.......................... (\3\)
------------------------------------------------------------------------
\1\ The maximum bandwidth that will be authorized for each particular
frequency in this band is detailed in the appropriate frequency table
in Sec. 101.147. If contiguous channels are aggregated in the 928-
928.85/952-952.85/956.25-956.45 MHz, the 928.85-929/959.85-960 MHz, or
the 932-932.5/941-941.5 MHz bands, then the bandwidth may exceed that
which is listed in the table.
\2\ 1250 KHz, 1875 KHz, or 2500 KHz on a case-by-case basis.
\3\ To be specified in authorization. For the band 92 to 95 GHz, maximum
bandwidth is licensed in one segment of 2 GHz from 92-94 GHz and one
0.9 GHz segment from 94.1 to 95 GHz, or the total of the loaded band
if smaller than the assigned bandwidth.
\4\ For exceptions, see Sec. 101.147(s).
\5\ A 12.5 kHz bandwidth applies only to frequencies listed in Sec.
101.147(b)(1) through (4).
\6\ For frequencies listed in Sec. 101.147(b)(1) through (4),
consideration will be given on a case-by-case basis to authorizing
bandwidths up to 50 kHz.
\7\ For channel block assignments in the 24,250-25,250 MHz and 38,600-
40,000 MHz bands, the authorized bandwidth is equivalent to an
unpaired channel block assignment or to either half of a symmetrical
paired channel block assignment. When adjacent channels are
aggregated, equipment is permitted to operate over the full channel
block aggregation without restriction.
Note to Footnote 7: Unwanted emissions shall be suppressed at the
aggregate channel block edges based on the same roll-off rate as is
specified for a single channel block in Sec. 101.111(a)(1) or in
Sec. 101.111(a)(2)(ii) and (iii) as appropriate.
\8\ For incumbent private operational fixed point-to-point stations in
this band (those not licensed as MVDDS), the maximum bandwidth shall
be 20 MHz.
[ 61 FR 26677 , May 28, 1996, as amended at 61 FR 44181 , Aug. 28, 1996; 62 FR 23167 , Apr. 29, 1997; 62 FR 24582 , May 6, 1997; 63 FR 6105 , Feb. 6, 1998; 65 FR 17449 , Apr. 3, 2000; 65 FR 38329 , June 20, 2000; 65 FR 59358 , Oct. 5,
2000; 67 FR 43038 , June 26, 2002; 68 FR 4956 , Jan. 31, 2003; 69 FR 3266 ,
Jan. 23, 2004; 70 FR 29997 , May 25, 2005]
CiteFind - See documents on FCC website that
cite this rule
Want to support this service?
Thanks!
Report errors in
this rule. Since these rules are converted to HTML by machine, it's possible errors have been made. Please
help us improve these rules by clicking the Report FCC Rule Errors link to report an error.